The Best Tips on How You Can Replace a Windshield
When there is a chip or crack on your windshield, chances are high that it will continue becoming bigger and therefore attractive and dangerous. When you take your car to be repaired and to get a new windshield, it may be expensive for you and therefore you should learn how to replace the windshield on your own. By reading this article, you will discover more about the most useful tips on how to replace the windshield.
The first step to take is to remove the old damaged windshield from your vehicle. For you to successfully remove the windshield, it is important to remove the rubber trim, peel the gasket from the groove and then remove the clips. The next thing is to separate the windshield glass from the pinch-weld using a razor to cut the urethane seal. To cut the urethane seal might be a challenge to you because it is very strong and adhesive. Ensure that you cut it from inside so that your careful not to break the glass since it can cause a mess. The next thing is to lift the windshield and it is important that you seek help because it is a two-person job. When you have lifted the glass, place it carefully on the ground where you will put it on top of a towel. This is going to avoid the mess of shattered glass where you have parked your vehicle or in the garage.
Before installing the new windshield, you should prepare the pinch-weld by using sandpaper to remove rust from it, passing water on it and then brushing it to clean away contaminants. You should then apply a layer of urethane primer to the black band that is around the perimeter of the windshield to prepare for the installation of the new windshield. To read more about how you can install your new windshield, visit the website of Windshield Guru.
Give about 24 hours for urethane dry before you can start driving again. The next step is to install the window gasket and you should start from one end and press it into the groove until you complete the whole perimeter of the windshield. One of the last steps is to replace the trim around the windshield after you have made sure that urethane has dried completely. If you follow the above steps, then you are going to replace your windshield within no time. If you are interested in reading other DIY windshield replacement tips, ensure that you visit this website.